A phase sweep can also be performed (as with CYCPHASE command) by adding a Cyclic Phase angle to both cos and sin terms in eq.3-2.Įxtra precaution has to be observed when dealing with non-component results (USUM, SEQV, SINT) or linearized stress, component results need to be obtained with eq.3-2 before computing non-component results: combining non-component results with eq.3-2 for basic and duplicated sector is not correct. The amplitude can be retrieve from the unprocessed results AMP = SQRT(UA^2+UB^2). To compute expanded results, User need eq.3-2 (Mechanical APDL > Cyclic Symmetry Analysis Guide >Cyclic Symmetry Overview > Postprocessing a Cyclic Symmetry > Using the /CYCEXPAND Command) Various commands (*GET, *VGET, …) gives you the unprocessed results but not as real and imaginary part but as real values for original and duplicate sector, so if you have n nodes in the sector, you need to get results for both nodes ii and ii+n (/CYCEXPAND) and PowerGraphics (/GRAPH) are both active. It can combine all appropriate components to produce theĪctual nodal solution for sectors 1 through 6 if cyclic expansion PRNSOL is listing an unprocessed component of a cyclic symmetry After /CYCEXPAND,OFF (or if no /CYCEXPAND has been issued), the following warning message is issued (may be PRNSOL, PRESOL or other):
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |